System will not turn on:
Check power plug and breakers.
Low water level alarm:
Add more water – the water level can be dropped during operation by the pump
due to water turbulence.
Low water level alarm turns on after a few seconds of operation:
Add more water – The pump generates “waves” – sometimes these waves will cause
the water level at the sensors to fl uctuate up and down. The waves sometimes drop
the water level right under the sensor and will cause a low water alarm. This is nor-
mal and you just need to add more water.
Temperature read does not match thermometer:
Keep in mind, Anova immersion circulators are calibrated to a scientifi c platinum
primary standard which is far more accurate than store thermometers.
Cover your tank with foil and wait about 15 minutes for temperature equilibration –
the number one source of temperature read differences is an uncovered tank. If you
want your system to match your personal thermometer, use the calibration function
provided in the phone application to change the temperature offset.
Lights in house are slightly fl ickering when system is on:
This is normal as the circulator is modulating power.
System will not pair:
Power circulator off for 10 seconds when power back on. Also the system is designed
to pair in APP. Please use the APP to pair the system.
25
To Next Page
Loading...
