Manual Revision Code: FRONTLINE-SRL-04 10-19-20
7
corrosion-causing elements to enter the housing. After cleaning, pull the lifeline all the way out, allow the
unit to air dry, then retract the lifeline into the unit. Do not allow the lifeline to freewheel back into the
housing. Tag as " UNUSABLE" and store separately any unit in need of or scheduled for maintenance.
DO NOT use heat to dry.
DO NOT attempt to disassemble the SRL.
Service:
The SRL is designed to be used installed in an anchor cradle or attached overhead. While it may be used
horizontally on a flat surface, the user may encounter a situation where the lifeline will not retract all the
way due to misalignment and bunching up on the drum. If this happens, hang the SRL from a height
sufficient to allow the full working length of the lifeline to be pulled off the drum, then allow the SRL to
retract the lifeline completely. Maintain tension on the lifeline. Use a tag line if necessary.
Storage:
Hang the SRL in a cool, dry, clean environment out of direct sunlight. Position the SRL so excess water can
drain out. Avoid exposure to chemical or caustic vapors. Thoroughly inspect the SRL after any period of
extended storage.
Specifications:
SRLs have been tested and certified to the performance requirements of the standard(s) identified on the
labels. SRLs documented in this instruction meet the following Arrest Force and Arrest Distance maximums
when tested in accordance with ANSI Z359.14.
Average Arresting Force
≦
≦
Maximum Arresting Distance 24”
*User weights above 310 lbs. are not within the scope of ANSI/ ASSE Z359.14
The above results are valid when the SRL’s lifeline is secured overhead.
Dimensions:
Average working range for each kind of the SRLs are the different, such as the RPGC30 is 30ft(9.1m),
RPGC50 is 50ft(15.2m), RPA061S, RPA062S, RPA062R, and RPA062RA are 6ft(1.8m), RPA091TB and
RPA092TB are 9ft(2.7m), RPA121R 12ft(3.6m), but will vary slightly with length differences in the various
End Connector options.
Labeling:
Illustrates the SRLs labeling. All labels on the SRL must be present and fully legible.
RPA061 S