Customer Support – 0800 080 6781 (UK Toll Free) or +44 207 157 9795
ANSIO 5005 | 5012 (J21v01)
support@ansio.co.uk
GETTING TO KNOW YOUR KETTLE
1. Spout
2. Power base
3. Top lid
4. Lid release button
5. Handle
6. Water level indicator
7. On/off switch
8. Power cord with plug
BEFORE USING YOUR KETTLE
• Remove all the packaging from the kettle and position it on a secure,
stable, dry and flat work surface away from any edges.
• This kettle should only be connected to a British Standard power outlet
installed by an approved electrician. The kettle should not be connected
to an extension cord or plug.
• This appliance has been incorporated with a grounded plug. Ensure the
wall outlet in your house is well earthed.
• Do not let the power cord hang over the edge of a table or kitchen counter,
touch a hot surface or become knotted, trapped or pinched. While in use,
wind the excessive cord to avoid overhanging in the work surface.
• Remove the kettle from the power base and open the lid. Fill the kettle
up to the max mark and close the lid.
• Place the kettle back in its base and turn it on by pressing the switch
down.
• Clean your kettle by boiling a full kettle (1.7 L) of water twice and then
discarding the water.
NOTE: The maximum capacity of kettle is 1.7L
To Next Page
Loading...