EN
7
Symbols
Safety class II.
Class III.
Approved as per
applicable directives.
Recycle discarded product
in accordance with local
regulations.
TECHNICAL DATA
Input voltage, transformer 230 V
~
50 Hz
Output voltage, transformer 6 V DC
Output 6 W
No. of LEDs 160
Safety class II
Protection rating IP44
INSTALLATION
See illustration for installation instructions.
FIG. 1
USE
1. Connect the installed product to the
transformer.
2. Plug the plug into a power point.
SAFETY INSTRUCTIONS
• Do not connect the product to a power
point while the product is still in the pack.
• Designed for indoor and outdoor use.
• Check that no light sources are damaged.
• Do not connect two or more string lights
together electrically.
• No parts of the product can be replaced,
or repaired. The whole product must be
discarded if any part is damaged.
• Do not use sharp or pointed objects during
assembly.
• Do not subject the power cord or wires to
mechanical stress. Do not hang any objects
on the product.
• This is not a toy. Do not allow children to
play with the product.
• Be careful if using the product near children.
• Disconnect the transformer from the power
point when the product is not in use.
• This product must only be used together
with the supplied transformer and must
never be connected directly to the mains
supply without a transformer.
• The product is not intended to be used as
general lighting.
• Recycle products that have reached the end
of their useful life according to local
regulations.
WARNING!
The product must only be used when all the
seals are correctly tted.
To Previous Page
Loading...