TECHNICAL DATA
Input: 100-240V / 50-60Hz
Protection Class: II
Charging currents: 6 x AAA (Micro) = 400mA
6 x AA (Mignon) = 1000mA
4 x C (Baby), D (Mono) = 1000mA
2 x 9V Block = 60mA
FAULT DIAGNOSIS
The charger has no function:
> check, if the mains lead is correctly connected to
the power outlet
> check, if the outlet has power; connect another
functional electrical device to check the power
outlet
The inserted batteries are not being charged:
> check, if the batteries are inserted with the
correct polarity; cylindrical batteries have to be
inserted so that the plus pole is near to the LED;
insert batteries into the charger as per the battery
symbol engraving in the charging slot
> ensure, that you inserted suitable rechargeable
batteries into the charging slot; suitable batteries
for charging are only NiCd/NiMH battery types of
AAA, AA, C, D, and 9V block. Other problems: please
contact our service department (see “ADDRESS”)
DISCLAIMER
Information in these operating instructions can be
changed without prior notice. ANSMANN cannot
accept liability for direct, indirect, accidental or
other claims or consequential damages originated
by not using this device as indicated by these
operating instructions.
WARRANTY NOTICE
We hereby offer a 3 year warranty on this charger.
This does not apply to damage caused by low-
quality batteries leaking inside the charger.
ADDRESS
ANSMANN AG
Industriestr. 10
D-97959 Assamstadt / Germany
hotline@ansmann.de
www.ansmann.de
Technical details subject to change without prior
notice. No liability accepted for typographical errors
or omissions. 09/2010
All manuals and user guides at all-guides.com
To Next Page
Loading...
Need help?
General
