13
4 Connect the USB cable to the Micro USB connection on the wall
mount.
5 Firmly press the USB cable into the strain relief.
6 Screw on the wall mount.
7 Connect the USB cable to a USB voltage source with at least 1 A
output current.
CHARGING
Option A: Place the product in the wall mount.
Option B: Charge the product via the built-in Micro USB connection.
1 Open the rubber cap on the Micro USB connection.
2 Use a suitable cable to connect a USB voltage source with at least 1
A output current.
3 After charging, unplug the USB cable and close the rubber cap.
Power failure system
• Begin charging while the product is turned on.
• As soon as the product is supplied with power, it turns itself off.
• If the power supply is interrupted, the product turns on automatically
with approx. 20 % luminosity.
• The product turns off again automatically when the power supply is
reconnected.
Deutsch | English | Français | Español | Português
Svenska | Italiano | Nederlands
Deutsch | English | Français | Español | Português
Svenska | Italiano | Nederlands
4.
5.
6.
To Next Page
Loading...
Need help?
General