What to do if my ANSMANN LITHIUM 4 Battery Charger displays "Err"?
If your ANSMANN Battery Charger displays "Err", it indicates that the battery polarity is reversed or the battery is defective. To resolve this, insert the battery with the correct polarity or discard the defective battery.
Why does my ANSMANN LITHIUM 4 Battery Charger beep frequently?
If your ANSMANN Battery Charger beeps frequently, it means that the audible signal has not been deactivated. To stop the beeping, deactivate the audible signal by double-clicking the function button.
What to do if ANSMANN LITHIUM 4 Battery Charger displays "Err" and "Low input"?
If your ANSMANN Battery Charger displays both "Err" and "Low input", it means the power supply capacity is too low. Use a more powerful power supply to fix this.
Observe all information, insert batteries with correct polarity, and check for damage before charging.
Dispose of defective batteries properly. Operate only in dry rooms away from combustibles.
Warning about fire and explosion risks. Never use non-rechargeable batteries.
Avoid extreme temperatures, rain, damp areas, and covering the product during operation.
Crucial instruction for manual LiFePO4 mode selection to prevent battery/charger damage.
General| Charging Channels | 4 |
|---|---|
| Number of Charging Slots | 4 |
| Supported Battery Types | Li-Ion |
| Input Voltage | 100-240 V AC |
| Output Voltage | 4.2 V |
| Compatible Battery Types | 18650, 14500, 10440 |
| Charging Time | Varies depending on battery capacity |
| Protection Features | Reverse Polarity Protection, Short Circuit Protection, Overcharge Protection |
To Next Page