Ansul AUTOPULSE IQ-396X - AUTOPULSE IQ-396 X Operating Modes; Normal and Trouble Operation Modes

10 AUTOPULSE IQ-396X Programming Doc. 50402:B 07/22/96
If a detector exists in the control panel program, but is missing (no
response from the program), the control panel displays a screen similar to
the following:
 To delete the device from memory, press Enter. The next new device
appears in the display.
 To keep the device in memory, press <Esc>. The control panel
displays the Program Change screen.
Autoprogram Defaults
The following table contains descriptions for the fields that display in the
Autoprogram Default screen.
Autoprogram Default Fields
If using CPX-551 Ion detectors
in a duct application, set the
Alarm Sensitivity level to 1.
dleiFnoitpircseD
)OTOHP(EKOMS ehtfonoitcnufehtsenifedtahtrotcetedehtfoedocepyT
:rotceted
)taeH(golanA
)otohP(ekomS
)noI(ekomS
)resaL(ekomS
)itluM(ekomS
RDDAROTCETED
101
.)10sserdda=10;1pool=1(101:lebalmotsuctluafeD
tnevE-yb-lortnoC
noitauqE)EBC(
:noitcelesenoztluafeD
srotcetedtaeH10enoZ
srotcetednoI20enoZ
)tluafed(srotcetedotohP30enoZ
srotcetedresaL40enoZ
srotceteditluM50enoZ
rofsenozeromruofddasallewsasenozegnahcnacuoY
.EBCsrotcetedhcae
5:LA mralAevitisnestsaeleht9htiw,levelytivitisnesmralAehT
otrefeR.levelmralAevitisnestsomeht1dnalevel
.noitamrofnieromrofCxidneppA
0:AP rebmunagnitteslevelytivitisnesmralA-erPehtswohS
:swollofsa9dna0neewteb
.mralA-erPon0
.levelmralA-erPevitisnestsom1
.levelmralA-erPevitisnestsael9
.noitamrofnieromrofCxidneppAotrefeR
** rotceteditlumrotcetedehtsetacidniot)*(ksiretsatsrifehT
:edom
ehthtiwnoisicedmralas'rotcetedehtsenibmocA
.evobasserddatxen
ehthtiwnoisicedmralas'rotcetedehtsenibmocB
.wolebsserddatxen
txenehthtiwnoisicedmralas'rotcetedehtsenibmocC
.woleb.sserddatxenehtdnaevobasserdda
PROGRM SMOKE (ION) DETECTOR ADDR 133
DEVICE NOT ANSWERING DELETE FR MEM? D133
Type code
2-digit address
SLC Loop number (1 or 2)
D (Detector), M (Module)