Ansul AUTOPULSE IQ-396X - Fire Alarm and Supervisory Signal Handling

AUTOPULSE IQ-396X Programming Doc. 50402:B 07/22/96 11
After programming all SLC-connected devices into the system, you can
modify or delete points using the Option 2, Point. From the Program
Change screen, press <2> to display the Point screen:
The Modify Point and Delete Point screens let you edit or delete points
for a detector, module, or output circuit. To select a device, follow these
steps:
You can now modify or delete a point. To modify a point for a detector,
module, or output circuit: press <1> to display the Modify Point screen;
or press <2> to display the Delete Point screen.
How to modify a point
Modify Point screen
Device Address
Enter
AAA,EAAA,E
AAA,EAAA,E
AAA,E
Address (01-99)
The Type Code is used to
change the function of a
point.
Point Programming
0=CLR 1=AUTO 2=POINT 3=PASSWD 4=MESSAGE
5=ZONES 6=SPL FUNCT 7=SYSTEM 8=CHECK PRG
2
When you select a device, the control panel returns a screen that displays
information about the point. For example, the following figure shows
information for a sample monitor module (M101) on the panel display:
Loop (1=L1; 2=L2)
...tcelesoT...gniwollofehtoD
elbasserddA
rotceteD
sserP
H
rotceteddna)2ro1(rebmunpoolehtepyT
)99-1(sserdda
sserP
R
elbasserddA
eludoM
sserP
I
eludomehtdna)2ro1(rebmunpoolehtepyT
)99-1(sserdda
sserP
R
tuptuOlenaP
tiucric
sserP
J
)8-8(hguorht)1-0(:sserddatiucrictuptuoehtepyT
sserP
R
POINT PROG. 1=MODIFY POINT
2 = DELETE POINT
Delete Point screen
POINT PROG. ENTER: DETECTOR=*,AAA,E
MODULE=#,AAA,E OUTPUT CKT=$,A-A,E
Point Screen
DELETE POINT. ENTER: DETECTOR=*,AAA,E
MODULE=#,AAA,E OUTPUT CKT=$,A-A,E
Continued on the next page...
The Type Code selection blinks, meaning you can press the Next or
Previous keys to scroll through the Type Code selections. Refer to the
table, Monitor Module Type Codes which lists the function for all
Monitor Module Type Codes. You can also do the following:
1) Use the arrow and alphanumeric keys to modify point information,
such as the CBE equation.
2) When finished modifying a point, press <Enter>; then use the Next
and Previous keys to select another point.
PROGRM MONITOR MODULE ADDRESS 101
ZO4 Z Z Z Z M101
Blinking Type Code Selection
2-digit address
SLC Loop number (1 or 2)
D (Detector), M (Module)