Ansul AUTOPULSE IQ-396X - Annunciator Display Selections; Annunciator Screens and ACS Group Configuration

18 AUTOPULSE IQ-396X Operations Doc. 50403:B 07/22/96
Read Status
For detailed information on
annunciators, refer to
Appendix A, Annunciators,
in the IQ-396X Installation
Manual.
puorGnoitceleSSCAyalpsiDrotaicnunnA
165-1senoZ+sutatSUPC
2senoZcepS61&4-1stkCdnI,99ot75senoZ
3461ot101seludoMtnegilletnI
4462ot102seludoMtnegilletnI
5692ot562&691ot561seludoMtnegilletnI
6461ot101srotceteD
7462ot102srotceteD
8692ot562&691ot561srotceteD
9)stp46(seludoMlenaP
0ro*sserddAtAdellatsnItoNrotaicnunnA
ANNUN SELECTION: A1=6 A2=7 A3=9 A4=*
A5=* A6=* A7=* A8=* A9=* A10=* UDACT=Y
ANNUN SELECTION: A1=* A2=* A3=* A4=*
A5=* A6=* A7=* A8=* A9=* A10=* UDACT=N
A=Address
Figure 39 shows annunciator selections for addresses A1-A3 (addresses A4-
A10 are not selected).
 Annunciators set to Address 1 display the status of detectors 1-64 on
loop1 (ACS Selection Group 6);
 Annunciators set to Address 2 display the status of detectors 1-64 on
loop2 (ACS Selection Group 7); and
 Annunciators set to Address 3 display the status of the panel modules (ACS
Selection Group 9).
Figure 39 shows an example of ACS selections in Annunciator Selection
Screen 1:
Press <Z>, <S1>, <Enter> to display Annunciator Selection 1 Screen which
typically displays as shown in Figure 36:
Figure 39: Annunciator Selection Screen 1 Example
Figure 38: ACS Selection Groups
Use the Annunciator Selection screen to select information that will display
on the ACS annunciators. Figure 38 contains the ACS display selections.
If UDACT=N, the control panel displays the Annunciator Selection 2 Screen,
addresses A11A19, as shown in Figure 37:
ANNUN SELECTION2 A11=* A12=* A13=*
A14=* A15=* A16=* A17=* A18=* A19=*
Figure 37: Annunciator Selection 2 Screen
Figure 36: Annunciator Selection 1 Screen
Annunciator Display
Selections
Example of Annunciator
Display Selections