Ansul AUTOPULSE IQ-396X - Selecting AMG Tones and Messages; Setting the AMG Switch for Tones and Messages

AUTOPULSE IQ-396X Operations Doc. 50403:B 07/22/96 23
Overview
Selecting AMG Tones and Messages
You can select AMG tones and messages by setting AMG DIP switches. An
AMG appears as an annunciator to the system and operates on address 01.
Operating an AMG, therefore, affects AUTOPULSE IQ-396X programming
and annunciator switch settings. Refer to the table AMG DIP Switch Pins,
for setting up the AMG-1.
1) Select ACS=Y in the System Function screen.
Note: Setting switch 3 to on
(R i l ) di bl th AMG All
SIL INH=000 AUTO=000 VERIFY=00 USA TIME
TERM_SUPERV=NO LocT BLINK=Y ST=4 ACS=N
System Function Screen
Annunciator Selection Screen
ANNUN SELECTION:
A1=1A1=1
A1=1A1=1
A1=1 A2=* A3=* A4=*
A5=* A6=* A7=* A8=* A9=* A10=* UDACT=Y
2) Enter Annunciator Selection Group 1 for Annunciator Address 1.
Annunciator Address 1
Set the pins on the AMG DIP switch as follows:
 To set a switch on, push the rocker to on.
 To set Message Select switches, refer to Tables 1 and 2 on the following
pages. For example, if you set switch 2 to off, refer to the settings in
Table1 for setting switches 6-8.
AMG DIP Switch
Setting the AMG Switch
AMG DIP Switch Pins
rebmuNhctiwSnOffO
oiduAlevelwoL1fonoisivrepuseriw-4
.oiduAleveLwoL
delbasiD
tcelesegasseM/enoT22elbaTtceleS
8-6sehctiwsgnittesrof
1elbaTtceleS
-6sehctiwsgnittesrof
8
ylnOevieceR3llAGMAehtselbasiD
.noitcnufllaC
delbasiD
AelbanEMARecioV4niegassemadroceR
AMARV
delbasiD
BelbanEMARecioV5niegassemadroceR
BMARV
delbasiD
tceleSegasseM6sgnittesrof2dna1selbaTeeS
tceleSegasseM7sgnittesrof2dna1selbaTeeS
tceleSegasseM8sgnittesrof2dna1selbaTeeS