Ansul AUTOPULSE IQ-396X - ATG-2 Operating Mode Selection; Operation Mode Settings for ATG-2

30 AUTOPULSE IQ-396X Operations Doc. 50403:B 07/22/96
You can set the ATG-2 for one of two modes of operation: 1) remote
paging only; or 2) tone generation and paging capability. Set DIP
switches 5 and 6 as shown in the following table. After setting DIP
switches, test the ATG-2.
Selecting Tones for the ATG-2
Operation Mode Settings
PAGE SELECT Switch 
Push until the LED on the
selected channel lights.
Paging with an ATG-2
...oT...sihtoD
gnigapehttceleS
lennahc
.hctiwstceleSegaPehtsserP
evitcaehtyfireV
lennahc
.sDELrotacidnilennahcehtkcehC
egaPehtfoedisehtnohctiwsehtsserP
ehtotnikaepsdnaenohporcim
enohporcim
PID
hctiwS
gnigaPetomeR
ylnO
enoTdnagnigaP
etareneG
5nOffO
6ffOnO
Select Operating Mode
Setting Paging Options with
the Page Select Switch