Ansul CHECKFIRE 210 - Front Panel Indicator Details; LED Amber or Red Indications

PAGE 5
FRONT PANEL INDICATORS (Continued)
STEP 2 (Continued)
009290
c. LED amber or red indications
!
Amber: RELEASE Circuit Fault,
pulsing 1 x 10 sec.
Red: DETECTION Circuit Alarm Condition,
pulsing 1 x 10 sec
Amber: DETECTION Circuit Fault,
pulsing Amber 1 x 10 sec.
Red*: System DISCHARGE activated pressure
switch, steady-on for remaining Release
Activated.
Pulsing 1 x 10 sec. during Post Release
Activated
Amber: ISOLATE Mode, pulsing 2 x 30 sec.
Red: SHUTDOWN status, pulsing 4 x 1 sec.
during Alarm Condition.
Steady-on during Release Activated.
Pulsing 1 x 10 sec. during Post Release
Activated.
* Australian Standard: Only active when “Pressure Switch
Feedback” is programmed.