Form No. Pages
VII. TESTING AND PLACING IN SERVICE 7-1 – 7-3
TESTING ELECTRIC DETECTION SYSTEM – AUTOPULSE CONTROL SYSTEM 7-2
TESTING ELECTRIC DETECTION SYSTEM – ANSUL AUTOMAN II-C RELEASE 7-2
TESTING SELECTOR VALVE 7-2
DISCHARGE TEST 7-2 – 7-3
VIII.RESETTING AND RECHARGE 8-1 – 8-4
CLEAR ELECTRICAL EQUIPMENT 8-1
CHECK ELECTRICAL AND MECHANICAL EQUIPMENT 8-1
Piping and Nozzles 8-1
Selector Valve 8-1
Electric Detection System 8-1
Pressure Switch 8-1
Resetting the HF Actuator 8-1
Resetting the Booster Actuator 8-1
PLACE SYSTEM BACK IN SERVICE – CV-98 VALVE SYSTEMS 8-2
RECHARGE INERGEN CYLINDERS 8-2
MANUAL VALVE ACTUATOR 8-3
RESETTING SELECTOR VALVE 8-3
MANUAL PULL STATION 8-3
REPLACE ANSUL AUTOMAN II-C CARTRIDGE 8-3
NOTIFY OWNER 8-3
PRESSURE TEMPERATURE CHART 8-4
IX. INSPECTION 9-1
X. MAINTENANCE 10-1 – 10-4
ANNUAL MAINTENANCE EXAMINATION 10-1 – 10-4
General Information 10-1 – 10-2
Thermal Detection/Electric ANSUL AUTOMAN II-C Release 10-3
Electric Detection/AUTOPULSE Control System 10-3 – 10-4
XI. TYPICAL APPLICATION 11-1 – 11-7
Table of Contents
7-15-02 REV. 1
Page 4
To Next Page
Loading...