Ansul INERGEN - Page 73

DATE: ______________________________________________________________________________ QUOTE/JOB NUMBER: ________________________________________________________________
CUSTOMER: ________________________________________________________________________
VOLUME CALCULATIONS: AREA 1 AREA 2 AREA 3 AREA 4 AREA 5
Area Name:
Length (ft.):
Width (ft.):
Height (ft.):
Area (sq. ft.):
Volume (cu. ft.):
Volume Reductions:
Structural Reductions (cu. ft.):
Total Reduced Volume:
(Volume – Structural Reductions)
ROOM MINIMUM AMBIENT TEMP.:
DESIGN CONCENTRATION:
FLOODING FACTOR:
(From Table)
INITIAL INERGEN QUANTITY CALC.:
INERGEN Quantity (cu. ft.):
(Total Reduced Volume x Flooding Factor) or (Formula from Design Manual)
ALTITUDE CORRECTION:
Height Above or Below Sea Level:
Factor:
(From Design Manual Table)
ACTUAL INERGEN QUANTITY (cu. ft.):
(Initial INERGEN Quantity x Altitude Correction Factor)
TOTAL INERGEN QTY. (cu. ft.):
(Sum of all Actual INERGEN qty’s)
SECTION V UL EX-4510 12-1-01 Page 5-17
INERGEN
®
SYSTEM DESIGN CALCULATION WORKSHEET