Note: the produce design and specification may be altered for improvement
without any further notice.
5. Product Installation
5.1 Unpacking
After unpacking, please check if the device is damaged during transport and the
accessories described in the packing list are complete. If any damage or missing
of the accessories, please contact our dealer timely.
Parts and accessories provided with the device:
User manual------1 copy Certificate of conformity------1 copy
Warranty card------1 copy
5.2 Installation conditions
Indoor: solid and flat ground without any shake.
Clean environment with good ventilation and without direct sunlight and
harmful, corrosive gas.
It is recommended to provide a ventilator and some air outlets with a
diameter of 25mm in the room where this device is installed, to discharge the
exhaust gas and guarantee the fresh indoor air.
In addition, an underground sewage pipe with an inner diameter of 25mm
should be equipped in the room to guarantee the removal of liquid waste
from the suction system.
This device should be installed near the power socket with reliable
grounding.
Keep this device far away from heat. No inflammable materials near it.
Enough space should be provided near the suction system for ventilation.
No direct or indirect contact with damp objects is allowed in the installation
site.
5.3 Requirements for normal operating environments
Ambient environment: +10℃ -- +40℃
Relative humidity: ≤70%
Atmosphere pressure: 700Hpa ~ 1060Hpa
5.4 Pipeline/signal line connection
connect the other end of the drainage pipe to the sewer pipe.
6. Cleaning and Maintenance
Regular maintenance for the dental suction system could reduce the frequency of
troubles and keep this device in good working condition, thus extending its
service life.
The operator must wear a mask and waterproof gloves in cleaning and
maintaining.
△ The following operations must not be carried out after the power is cut
off!
6.1 External cleaning
Be sure this device has stopped operating, and the power supply has been cut off
and unplugged before cleaning.
Please immerse a soft towel into warm water and then wring it dry to wipe
the device surface.
Attention: please don’t wipe the control panel with alkaline detergent.
Attention: wiping the device surface with a coarse or stained cloth with particles
may scratch this device, so please use a tidy soft cloth to clean.
6.2 Filter screen cleaning (*Note: If no , please ignore this item.)
It is recommended to clean the filter screen twice a week to prevent reducing the
sucking efficiency.
Be sure this device has stopped operating, and the power supply has been cut off
and unplugged before cleaning.
To Next Page
Loading...