3
Thank you for choosing Antari’s DNG-250 Low Fog Generator. The machine has some
terrific new features on top of the ones of its previous version DNG-200. With the 3.5
TFT color touch panel, users can operate more easily. The dimension is exactly the same
as DNG-200, but the output volume and continuity are comprehensively increased,
hence a total up-grate in performance. No CO
2
is needed for DNG-250 Low Fog
Generator; therefore, there’s no risk to human body nor environment. DNG-250 is a real
green effect machine.
Please follow these operation, safety and maintenance instructions to ensure a longer
and safe life of your DNG-250 Low Fog Generator.
Pay attention to all warning labels and instructions printed on the exterior of the machine.
Safety Instructions
Keep this device dry.
For indoor use only. Not designed for outdoor use.
The ideal operating temperature is between 5° and 40° Celsius.
Two sets of professional power cords are used by this machine. It is important to
confirm the electrical voltage before plugging the power cord into the power outlet.
Use a three plug grounded power outlet.
If the machine is moved or transported, it shall be stationed for one hour to allow the
coolant in the cooler to stabilize before using it again.
If the machine is moved horizontally, please station it for 5 minutes before starting
the operation again.
Please unplug the power cord or turn off the machine when it is not in use.
This machine is not water-proof. If moisture, water, or fog fluid gets inside the
housing, immediately unplug the unit and clean it. If the machine cannot be cleaned,
please contact a service technician or your Antari dealer before using it again.
No user serviceable parts inside. Refer to your Antari dealer or other qualified service
personnel. For adult use only. The fog machine must be installed out of the reach of
To Next Page
