Anthony Lifgtates, Inc. 4 AST, AST-L, and AST-PLUS Models
www.anthonyliftgates.com 800-482-0003
1. General Information
1.1 Introduction
Congratulations on selecting an Anthony Liftgates
TuckUnder™ liftgate.
All Anthony tuckunder model liftgates are factory
assembled, energized, and tested to ensure the highest
quality performance standards. AST, AST-L, and
AST-PLUS liftgates ship completely assembled for fast,
clean, and easy installation.
To ensure your liftgate will perform to your expectations,
we have provided this Installation Manual, which is
designed to provide you with the necessary installation
instructions and safety precautions for the installation of
the AST, AST-L, or AST-PLUS TuckUnder™ liftgates.
ALI-00355a
Typical Anthony Liftgates Tuckunder Model.
Note: This manual covers all AST model liftgates with a
serial number of XXXXXXX and greater.
1.2 General Safety
WARNING
Read and Understand
the Manual
The success or failure of
this liftgate to properly and efficiently operate will
depend on a thorough and proper installation. Failure
to read, understand, and follow the installation
instructions and safety recommendations in this
manual, before installing the liftgate, can result in
serious injury or death to the operator or bystander.
Also, read and understand the operating instructions
in the separate Operation Manual (also found in the
information packet) before beginning the installation.
1.3 State and Federal Regulations
1.3.1 Brakes
WARNING
When installed, the operation or
weight of this liftgate must not
alter or prevent vehicle
compliance to any existing State or Federal standards,
such as FMVSS 105 – Hydraulic And Electric Brake
Systems. Each truck frame manufacturer’s
recommendations should be consulted for compliance.
Also, make sure the weight of the liftgate and its
fully loaded capacity will not overbalance the truck,
possibly raising the front wheels off the ground.
1.3.2 Lighting
WARNING
When installed, the transport
position of this liftgate must not
alter or prevent vehicle
compliance to any existing State or Federal standards
such as FMVS 108 – Lamps, Reflective Devices, and
Associated Equipment. Each truck manufacturer’s
recommendations should be consulted for compliance.
1.3.3 Rear Impact Guards
WARNING
When installed, the transport
position of this liftgate must
provide protection against rear
impact, using State or Federal standards, such as
FMVSS 223 – Rear Impact Guards and FMVSS 224 –
Rear Impact Protection.
It is the duty of the installer to make sure that guards
are installed, if necessary, to fulfill these standards.
Anthony Liftgates offers a bolt-on bumper, which will
meet the requirements of this standard. Each truck
manufacturer’s recommendations should also be
consulted for compliance.
1.4 Basic Installation Instructions
1. This liftgate should only be installed by someone
with sufficient skills to understand the installation
and operation procedures, along with the use of any
equipment or tools used to install the liftgate. This
manual provides typical installation instructions, which
we believe to be the most desirable sequence. These
instructions cannot replace a qualified installer with
clear thinking and basic knowledge.
2. This manual provides easy-to-follow instructions,
along with photos and illustrations, which will help
guide the installation process. Safety precautions
have been clearly identified throughout each section
of this manual and must be followed.
3. A complete explanation of the safety terminology and
recommendations are included in section “2. Safety”
on page 5 of this manual and should be read
thoroughly before proceeding.
4. We urge the installer to call our qualified personnel if
you have installation questions.
To Next Page