Antsig AP700 - User Manual

To Next Page

VHF/UHF Masthead Ampliﬁer

Model: AP700

Thanks for purchasing this AP700 Masthead Ampliﬁer.

Before installation,

Please read this manual carefully and keep this manual

for further information.

APPLICATIONS

• For effective ampliﬁcation of the TV signal received by TV antenna(s) (approximately 30dB)

• Use in weak TV signal areas or for multiple TVs

• Use with individual VHF and/or UHF antennas or a single combination VHF/UHF antenna

INSTALLATION INSTRUCTIONS

Head Unit

VHF/UHF

Antenna

UHF

Antenna

Second TV

(if required)

To TV

(via “IN” connection

on power supply

)

1. Attach Head Unit to the mast

using cable tie supplied. (Fig 1)

2. Make connection to Head Unit

as shown (Fig 2).

Close cover after ensuring

cables are attached securely and

positioned correctly.

3. Attach the power supply to wall

or skirting board.

A ventilation gap of at least 25mm

should be left around the front and

sides of the unit.

4. Connect the downlead from

the head unit to the “IN” socket.

Connect the output lead from the

socket marked “TV” to the recieving

installation (satellite reciever, VCR,

TV etc). When all connections have

been made, plug power supply into

mains outlet and switch on - Yellow

light will illuminate.

Note: If light shows red colour

there is a short circuit on the “IN”

connection.

TIP: If installing ampliﬁer to old

antenna, ensure antenna is in good

condition and cable terminations

are secure.

Power supply

Wallplate

Fig 1 Fig 2

CPIN002337

AP700-BUN_CPIN002337.indd 1 29/03/12 10:17 AM

Need help?

Do you have a question about the Antsig AP700 and is the answer not in the manual?

Summary

Applications

Installation Instructions

Attach Head Unit to Mast

Secure the Head Unit to the mast using the provided cable tie, following the diagram in Fig 1.

Connect Cables to Head Unit

Connect cables to the Head Unit as illustrated in Fig 2, then securely close the cover.

Mount Power Supply

Fix the power supply unit to a wall or skirting board, ensuring a 25mm ventilation gap around its front and sides.

Connect Power and Output

Connect downlead to "IN" socket and output lead to "TV" socket. Plug in and switch on; yellow light indicates normal operation.

Safety Information

Indoor Power Supply Use

The power supply is designed solely for indoor use, with the plug needing to remain accessible for disconnection.

Warranty

Warranty Terms and Conditions

Details the 12-month warranty, exclusions, claim procedures, and consumer rights under Australian Law.