What to do if the Antunes, AJ VCT-2000 Toaster temperature display flashes "PH" continuously?
If the temperature display flashes "PH" continuously, it could be due to the Heat Shield not engaging the Conveyor Safety Interlock Switch. Try repositioning the Heat Shield so that it engages the Conveyor Safety Interlock Switch.
What to do if Antunes, AJ Toaster control display flashes "LO" continuously and buns are burning?
If the control display flashes "LO" continuously and the buns burn, the problem may be a failed platen thermocouple. Contact your maintenance person or Authorized Service Agency for assistance.
Why does the Antunes, AJ VCT-2000 control display flash "LO" continuously and buns not toast properly?
If the control display flashes "LO" continuously and the buns are not toasting properly, it could be due to the platen temperature being below 440ºF (226ºC). Allow the unit to warm up for 30 minutes and then recheck. If the control display still reads “LO”, contact your maintenance person or Authorized Service Agency.
Critical safety warnings, cautions, and guidelines for safe operation and maintenance.
Step-by-step guide for operating the toaster.
Explanation of fault codes and their possible causes and resolutions.
Instructions for daily cleaning of the release sheet, belt wraps, and toaster.
Detailed steps for replacing the conveyor belt wraps.
Warning about safety and general advice for troubleshooting.
Troubleshooting steps for conveyor not turning and inadequate toasting.
Troubleshooting for buns sticking/burning and new belt wrap fit problems.
Full text of the limited warranty, including coverage, exclusions, and disclaimers.
General| Model | AJ VCT-2000 |
|---|---|
| Type | Vertical Contact Toaster |
| Browning Control | Adjustable |
| Crumb Tray | Yes |
| Belt Width | 10 inches |
To Next Page
