Net Work TV MSD6A628 software upgrading (After service)
1, software upgrade tools and materials
* PC (WINDOWS XP system, USB2.0)
* AC100 ~ 240V power supply and power cord
* ISP programming board and cable
* ISP programming board driver
* USB flash drive (version 2.0, the capacity is not more than 2G)
* Upgrade software and boot files
2, preparation before upgrade.
Write down all signal ADC and white balance data in factory menu before upgrading (FLASH initialization may occur
after upgrade, color calibration data erased, and then revert to the written down data):
1. Under YPbPb signal source, press the MENU key to pop up the main menu, and then press 8202 by number keys to
enter the factory menu, select ADC ADJUST item, press the OK button to enter the next menu, move the cursor to the
MODE key, press the left / right cursor keys to select YPbPr (SD) items, recorded R-GAIN / G-GAIN / B-GAIN value
and R-OFFSET / G-OFFSET / B-OFFSET value.
2. Undert ADC ADJUST item and press OK to enter the next menu move the cursor to the MODE key, press the left /
right keys to move the cursor to select YPbPr (HD) items, recorded R-GAIN / G-GAIN / B- GAIN value and R-OFFSET
/ G-OFFSET / B-OFFSET value.
3. Under VGA signal source, press MENU in the main menu pops up, then press 8202 by number keys to enter the
factory menu, select ADC ADJUST item and press OK to enter the next menu, move the cursor to the MODE key, press
the left / right cursor keys to select YPbPr (SD) items, recorded R-GAIN / G-GAIN / B-GAIN value and R-OFFSET /
G-OFFSET / B-OFFSET value.
26
To Next Page
Loading...
