If there is no showing of [ Device Type eMMC ] upgrade cannot be conducted , please check the programming board is
properly connected and if main board can boot (main board can boot normally not display [ Device Type eMMC ,] need to
upgrade the software, copying it into U disk, press and hold the button panel VOL + button first and powering on main
board, wait for LED indicator on the machine flashes for about five seconds and then unplug the U disk and re- power
main board to display ) .
7. Check "Auto" icon in the menu settings are consistent with the figure below, and then click "Run" button to boot file to
program.
Click “Connet” button under tool bar, running
program top part will show【Device Type eMMC】
After click“Stop/Run”button，
if interface lower right corner
shows “Connecting.....” and tab
bar shows as “【 Device Type
eMMC】 “ means connecting is
failed or current main board can
only us U disk to upgrade.
33
To Next Page
