Programming progress bar will scroll now, after programming is finished, it will show “
Pass”。
7, Main board driver upgrade.
1. U disk formatted as FAT32 format, and then upgrade the software ( software name is MstarUpgrade, suffix is bin) put in
U disk .
2. Insert U disk into main board or programming TV fixture USB port , press VOL + key, then power on TV ( main board)
after about five seconds the TV ( remote control panel ) indicator flashes rapidly , indicating the TV is being upgraded ,
when the light stops blinking and goes out ( this process time-consuming is depending on the size of the main board
software , the greater the file the longer the software upgrade time , when the board is 270M, upgrade software takes
roughly three minutes ,when 500M , it is about four minutes ) , indicating that the upgrade is complete .
3. Notes：
a. the file name and case cannot be wrong , otherwise it will not be upgraded .
b. When using U disk to upgrade, sometimes after light does not flat after a TV remote control panel lights flickering
flashes ten seconds, this is upgrade failure. Normal upgrade remote panel lights flashing more than two minutes , place the
board in case of power failure in this case re- board software upgrade.
c.main board cannot be upgraded after powering on , please programming boot file again (Mboot.bin or
MbootUprade.bin).
8, after the upgrade is complete, install machine cover, before delivery, factory adjustment must be carried out :
1. powering on machine, press the MENU button on the remote control to the main menu pops up, then press 8202
followed by the number key to enter the factory menu , press the up / down keys to move the cursor to the "Other Options"
option Press the Up / Down keys move the cursor to the "Restore To Default" option by right the reset command , a black
screen for about 8 seconds and the machine automatically re- power on reset operation is completed .
Programming
r
ress
result
Execute button
34
To Next Page
Loading...
