2. Completed initialization within three minutes after inserting VGA signal wire and powering on machine (automatically
initializes started after factory menu reset is ) switch to VGA signal source . Press the MENU key to pop up the main menu, and
then followed by 8202 the number keys to enter the factory menu, press the Shift key to "ADC ADJUST" and press the OK
button to enter the next menu, press the left / right keys to move the cursor to select VGA item, then press shift keys to move the
cursor to the AUTO TUNE key and press the OK button to execute the self-adjusting command. There is a corresponding entry in
the AUTO TUNE Tip: SUCCESS, means self-adjusting qualified, FAILS, means self-tuning failure, need to self adjusting again.
3. under YPbPb source ,input 480i 100% color bar signal to machine . after press NEMU poping-up main menu , then
followed by 8202 the number keys to enter the factory menu , select ADC ADJUST item , press the OK button to enter the
next menu , press the left / right keys to move the cursor to select YPbPr (SD) item , press down keys to move the cursor to
the AUTO TUNE key and press the OK button to execute the self-adjusting color commands. There is a corresponding
entry in the AUTO TUNE Tip : SUCCESS , means self-adjusting qualified , FAIL , means self-adjusting is filed, needed to
adjust again.
35
To Next Page
Loading...
