AOK BC168 - Setup: Charge Voltage and Current; Setting Charge Cut-off Voltage; Setting Charge Current

- 4 -
2.Set up:
information tips: Long press the mode button to return to the standby mode.
a. Under standard mode, push MODE to enter charge cut-off voltage set up
mode.
b. Unde charge cut-off voltage mode, Push ↑ or ↓ to set up the cut-off voltage.
After that and then push MODE to enter charge current set up mode.
(setting range: 1.50V ~ 4.20V, default value: 4.20V, this only suitable Lipo
batteries, LiFe need to double check with the battery manufacturer.)
c. Under charge current mode, push ↑ or ↓, and then set up charge current.
After that and then push MODE to enter discharge cut-off voltage mode.
(setting range: 0.1A ~ 8.0A, default value 3.0A)