REMOTE CONTROL
2-WAY MOTORCYCLE ALARM SYSTEM
[ AL-630 ]
2-Way Motorcycle alarm system
Arm:
Disarm:
Locate motor:
Remote Start Engine:
Function Operation
Function Key
Locate motor
Keyboard lock
Disarm
Arm
Battery
Assistant function
Remote start/open light
Illegally starting alarm
Illegally starting alarm
Sending signal
Shocking alarm
Shocking alarm
Disarm/Iginition off
Arm/Anti-robbery
1. Arm/Mute arm: Press the button once, the siren will beep once , the alarm system is in
ARM mode. If move the motorcycle or ignition on, the siren will sound and the direction lights will
flash, the engine will be locked at the same time. And the remote controller will beep and show
icons in LCD display. Press any button, the icons will be removed.
2. Disarm: Press the button once, the siren will give 2 beeps, the direction lights would flash
twice, the motorcycle is in the DISARM status.
3. Locate motor: Press the button once, the direction light will flash 8 times, the siren will beep
8 times, and you can know where your motorcycle is.
4. Remote Start Engine: Press the button twice within 3s to start the engine. Press on the
button for 3.5s, turn on the background light. After starting the engine by remote controller, the
engine will be on until you stop it by remote controller. You can drive the motorcycle without using
the key, so make sure no other people can get access to you motorcycle when using this function.
5. Adjust Sensitivity: Adjust the sensitivity on the mainframe by hand, turn clockwise to increase
sensitivity, turn anti-clockwise to decrease sensitivity. The sensitivity has been adjusted well when
leaving factory.
6. Remote Cut off Engine: When the engine is running, press the button once to stop the engine.
(Please kindly note that remote starting engine is to remote cutting off engine.)
7. Anti-robbery and assistance: When the motorcycle is robbed and driven away, the owner-
driver can stop it by pressing the button once, the siren will sound urgently and the direction
lights will flash at the same time.
8. Code Learning: In disarm mode, put the motorcycle key in the key lock and turn it from ACC
OFF to ACC ON, 3 times in 3s, when the lights flash and the siren beeps once, press any button on
the remote controller within 10s, the direction lights will flash once, it means the system learn the
Code of the remote controller. The other remote controller can be learnt code in the same way.
( The code has been learnt well before leaving factory, the user need not learn it again if
unnecessary.)
Remark: one mainframe could learn at most two remote controllers once.
9. Keyboard lock : Press the buttons and at the same time and hold for 3.5 s to lock
keyboard ; press these two buttons for 3.5s again to unlock the keyboard.
To Next Page
Need help?
General
