AOPUTTRIVER AP-570C-APP ConnectInstructions
Steps 1：
Turn OFF ALL irrelevant bluetooth signal.（Including bluetooth signal from irrelevant
phones, speakers or other devices）.
Make sure that only your phone's Bluetooth signal is ON nearby,
otherwise clamp meter will auto connect with other irrelevant bluetooth signal.
STEP 2: (Clamp meter stays OFF during step 2)
Turn ON bluetooth on your phone ➤ Open the APP
STEP 3: (DO NOT enter the system's Bluetooth connection list to select the Bluetooth
signal, the meter will automatically connect nearby Bluetooth signals by itself)
Turn on the clamp meter ➤ Wait for about 30 sec
for the meter connect to the phone automatically ➤ "Start" button become green ➤
Press "Start" ➤ Ready to go
To Next Page
Need help?
General