What to do if the AOTAI ATIG315P circuit breaker keeps tripping?
If the circuit breaker trips automatically (except when working for a long time at high welding current), the IGBT module, three-phase rectifier, or output diode module may be damaged, or there could be a short circuit. Check and replace any damaged components.
How to fix AOTAI ATIG315P Welding System over-heat protection?
If the AOTAI Welding System is overheating, it could be due to the machine being too hot, a faulty temperature relay, or a damaged main control board. Shut down the welding machine and wait for it to cool down. If the problem persists, consider replacing the temperature relay.
Why is the welding current not stable on my AOTAI ATIG315P Welding System?
Unstable welding current in your AOTAI Welding System can be caused by a default phase in the power supply or a damaged main control board. Check the power supply and, if necessary, check and replace the main control board.
General| Brand | AOTAI |
|---|---|
| Model | ATIG315P |
| Category | Welding System |
| Language | English |
To Next Page
