ATTENTION: Monitor the laminator at all times when the machine is turned on.
DO NOT LEAVE UNATTENDED. Please operate in an open, dry place away from temperature
sensitive materials. Do not place anything on or near the machine when it is in operation.
After laminating please allow the unit to sit for 2 minutes so rollers can cool.
Always unplug unit before servicing. To clean rollers use laminator roller cleaner pads available
at office supply stores. Please follow instructions included with cleaner pads. The Limited
Liability Warranty applies to laminator only. Apache Laminators is not responsible for damage to
any other personal property.
TROUBLESHOOTING: If you experience issues, many times the laminator is either too hot or too
cold. Ensure the laminator heats up completely before using it and use a carrier or sheet of
paper on top only when necessary. During the preheat sequence, if the laminator produces an
excess amount of smoke, turn off the machine, unplug the unit and wait for the laminator to
cool down. Next, visually inspect the rollers to ensure that there is no foreign debris and remove
any if necessary. Also, make sure that the rollers are functioning and moving properly. If the
problem persists, please contact Apache customer support immediately.
CONTACT INFORMATION: The Laminator comes with a 1 Year Manufacturer’s Warranty that
does not require registration. If you experience any issues please contact us at the email listed
below.
Need technical assistance or have a question? Contact us by email at support@bbdservices.com.
Our customers are our #1 priority and we would be glad to assist you.
Thank You, The Apache Team
www.apachelaminators.com
© 2014 Apache Laminators
To Previous Page
Loading...
Need help?
General
