4. The angle can be determined by
the position of the bracket base
and the position of the H-hook on
the half-sphere ball. The factory
default force setting of this central
screw is adjusted for moving the
H-hook over the semi-sphere with
or without the cabinet being over
the hook. You can fasten or loosen
the central screw to influence the
turning force of the H-hook.
5. Now slide out the rubber security
piece from the back of the speaker,
slide the speaker on the H-hook
of the mounting bracket. Slide
the rubber part back in place to
lock and secure the cabinet. Plug
the euroblock connector into the
speaker.
6. Consider to hide the speaker cable
by guiding it through one of the 4
pre-cut cable entries on the sides of
the bracket base.
To Next Page
Loading...
