USER’S GUIDE
NetBotz Rack Monitor 200
89
How to Reboot, Reset Settings, and Clear Alarms
(Administration>General>Reset/Reboot)
Use the radio buttons and checkboxes on the Reset/Reboot Network Interface page to
perform the functions described below.
Option Description
Reboot Management
Interface
Restarts the Main Module. All configuration settings are retained.
Reset All
Exclude TCP/IP
Resets all configuration settings to system defaults and clears all alarms.
Configuration settings and alarms include the following: TCP/IP, Event
Configuration, Lost Communication Alarms, Temperature Rate Of
Change Alarms, Module Configuration Including Identifier Numbers.
(See the next row of this table for details.)
Select this option to exclude TCP/IP settings when the Reset All function
is executed.
Reset Only
TCP/IP
Event Configuration
Lost
Communication
Alarms
Temperature Rate
Of Change Alarms
Resets only the options below that you select.
Resets the TCP/IP configuration method to DHCP & BOOTP, and all
other TCP/IP settings to system defaults. For details, see TCP/IP
settings (Administration>Network>TCP/IP).
Resets all event actions to their default configuration, which includes
logging for all events and, for some events, includes e-mail notification.
For events with default e-mail notification, the notification settings
include all recipients added to the system. (For details on event
configuration, see Configuring event actions.)
Clears a lost communication or device disconnected alarm caused when
communication is lost to a device, for example, when you intentionally
remove a device from the system. (For troubleshooting details on this
alarm, see Device Disconnected (or Lost Comm) Alarms.)
Clears an alarm caused when a temperature rate of change is
exceeded. (For details on rate-of-change settings, see Temperature &
Humidity page.)
To Next Page
Loading...