Quick Start: Network Management Card – DC Series 7
Quick Configuration
Control console
After you log on at the control console, either as described in
“Local access to the control console” on page 4 or as described
in “Remote access to the control console” on page 6:
1. Choose Network from the Control Console menu.
2. Choose TCP/IP from the Network menu.
3. If you are not using a BOOTP server to configure the
TCP/IP settings, change the BOOTP setting to
Disabled.
4. Set the System IP, Subnet Mask, and Default Gateway
address values.
5. Press
CTRL-C to exit to the Control Console menu.
6. Log out (option 4 in the Control Console menu) to have
the changes take effect.
Note
If you disconnected a cable during the procedure
described in “Local access to the control console”
on page 4, reconnect that cable and restart the
associated service.
To Next Page
Loading...
