Need help?Do you have a question about the APC Network Management Card AP9617 and is the answer not in the manual?
General| Model | AP9617 |
|---|---|
| Product Type | Network Management Card |
| Humidity | 0% to 95% non-condensing |
| Encryption Algorithm | SSL, SSH |
| Compatibility | APC Smart-UPS, Symmetra |
| Network Interface | 10/100 Mbps Ethernet |
| Protocols Supported | HTTP, HTTPS, SNMP, Telnet, SSH |
| Security | Password protection |
| Features | Remote monitoring and control, event notification |
| Power Supply | Via UPS |
| Operating Temperature | 0°C to 40°C |
| Weight | 0.5 lbs |
| Compliant Standards | FCC |
| Authentication Method | RADIUS, LDAP |
Instructions for disconnecting power from Symmetra and Silcon UPS models.
Steps to disconnect AC and DC power from Smart-UPS or Matrix-UPS before installation.
Ensure expansion chassis are disconnected from all power sources.
Highlights new capabilities like Syslog messages and DHCP support.
Lists standard features common across management cards, like logging and notifications.
Details features specific to AP9618 (modem) and AP9619 (environmental monitoring).
Information on using upgrade kits to convert existing management cards.
Describes the environmental monitoring capabilities of AP9618/AP9619.
Details the analog modem functionality for out-of-band communication on AP9618.
General introduction to installing the management card in various UPS types.
Instructions for safely disconnecting power from UPS systems before installation.
Steps for physically installing the Network Management Card into the UPS slot.
Introduction to installing the card in expansion or triple chassis.
Explains when and how to use the optional AC adapter for chassis.
Procedure for disconnecting power from the expansion chassis.
Steps for installing the Network Management Card into a chassis slot.
Requirements for configuring TCP/IP settings before network operation.
Lists methods for setting IP address, subnet mask, and default gateway.
Guide to using the wizard for configuring management cards.
How to configure network settings using BOOTP or DHCP servers.
Detailed steps for configuring the card using a BOOTP server.
Detailed steps for configuring the card using a DHCP server.
Instructions for accessing the control console via a local serial connection.
Instructions for accessing the control console remotely using Telnet.
Steps to set IP, subnet mask, and gateway via the control console.
Introduction to different interfaces for accessing the configured card.
How to access and configure the card using a web browser.
How to access the control console using Telnet from a subnet.
Using an SNMP MIB browser for network management access.
Using FTP for firmware updates and log access.
Using the wizard for configuring multiple cards over the network.
Using the analog modem for dial-in access to the AP9618 console.
To Next Page