APC Network Management Card AP9617 - How to Access a Configured Network Management Card (Continued); FTP Access; APC Management Card Wizard Usage; Analog Modem Access (AP9618)

How to Access a Configured Network Management Card
FTP
You can use
FTP
(enabled by default) to download new
firmware to a Management Card, or to access a copy of a
Management Card’s event or data logs.
1. At a command prompt, type ftp address and press
E
NTER
, where address is the Management Card’s
IP
address.
2. Enter the User Name and Password (
apc
by default).
APC
Management
Card Wizard
You can use the
APC
Management Card Wizard to configure
multiple Management Cards over the network.
Analog modem
(AP9618)
The AP9618 Network Management Card EM/MDM has an
internal analog modem you can use for dial-in access to its
Management Card’s control console.