APC AP9617 - Watchdog Features; Overview; Network Interface Watchdog Mechanism; Resetting the Network Timer

Quick Start: Network Management Card – DC Series 5
Quick Configuration
To continue the procedure for either type of equipment:
3. Run a terminal program (such as HyperTerminal
®
), and
configure the selected port for 2400 bps, 8 data bits, no
parity, 1 stop bit, and no flow control, and save the
changes.
4. Press
ENTER to display the User Name prompt.
5. Use apc for the user name and password.
See “Control console” on page 7 to finish the
configuration.