7Automatic Transfer Switch Installation and Quick Start
Device IP Configuration Wizard
You can use the Device IP Configuration Wizard on a Windows NT
®
4.0, Windows 2000
®
, Windows
2003, or Windows XP computer to discover unconfigured Automatic Transfer Switches and configure
their basic TCP/IP settings.
To configure one or more Automatic Transfer Switches by exporting configuration settings from a
configured Automatic Transfer Switch, see “How to Export Configuration Settings” in the User’s Guide
on the Utility CD.
1. Insert the APC Automatic Transfer Switch Utility CD into a computer on your network.
2. Select the Device IP Configuration Wizard from the main menu.
3. Wait for the Wizard to discover the first unconfigured Automatic Transfer Switch, then follow the
on-screen instructions.
Note: If you leave the Start a Web browser when finished option enabled, you can use apc for
both the User Name and Password to access the Automatic Transfer Switch through your
browser.
BOOTP & DHCP configuration
The Boot Mode Setting, a TCP/IP option in the Automatic Transfer Switches Network menu, identifies
how the TCP/IP settings will be defined. The possible settings are Manual, DHCP only, BOOTP only,
and DHCP & BOOTP (the default setting).
Note: The DHCP & BOOTP setting assumes that a properly configured DHCP or BOOTP server is
available to provide TCP/IP settings to Automatic Transfer Switches.
If these servers are unavailable, see:
“Device IP Configuration Wizard” on this page.
“Local access to the control console” on page 12.
“Remote access to the control console” on page 13.
With Boot Mode set to DHCP & BOOTP, the Automatic Transfer Switch attempts to discover a properly
configured server. It first searches for a BOOTP server, then a DHCP server, and repeats this pattern until
it discovers a BOOTP or DHCP server. For more information, see “BOOTP” on page 8 or “DHCP” on
page 8.
To Next Page
Loading...
Need help?
General
