APC H15 - Using the SELECT Push Button

- 15 -
Using the SELECT Push Button
Pressing just the Select push button, allows you to view H15 status infor-
mation (Power, V out and I out (“I” is the symbol for current), V in and
FREQ, Serial Number and Firmware Version), as defined in the following
paragraphs:
Power — The Power display (Figure 13) displays the power draw (how
much capacity, as a percentage (%), is being used by the currently attached
load).
Figure 13. Power Display
Vout / Iout — Pressing the Select push button again will cause the H15 to
display the voltage output and the currently attached load in Amps
(Figure 14).
Figure 14. Vout / Iout Display
Vin / Freq — Pressing the Select push button again will cause the H15 to
display the voltage input and frequency (Figure 15).
Figure 15. Vin / FREQ Display
Power = 0 VA
0%
Vout = 123 Vac
Iout = 0.0 A
Vin = 123 Vac
Freq = 60 Hz