APC UPS AP9630 - Appendix A: Supported Commands

UPS Network Management Card 2 User’s Guide98
Appendix A: List of Supported Commands
?
about
alarmcount
[-p [all | warning | critical]]
boot
[-b <dhcp | bootp | manual>]
[-c <dhcp cookie> [enable | disable]]
[-v <vendor class>]
[-i <client id>]
[-u <user class>]
cd
console
[-S <disable | telnet | ssh>]
[-pt <telnet port #>]
[-ps <ssh port #>]
[-b <baud rate> [2400 | 9600 | 19200 | 38400]]
date
[-d <“datestring”>]
[-t <00:00:00>]
[-f [mm/dd/yy | dd.mm.yyyy | mmm-dd-yy |
dd-mmm-yy | yyyy-mm-dd]]
[-z <time zone offset>]
delete
dir
dns
[-OM [enable | disable]]
[-p <primary DNS server>]
[-s <secondary DNS server>]
[-d <domain name>]
[-n <domain name IPv6>]
[-h <host name>]
eventlog
exit
format
ftp
[-p <port number>]
[-S <enable | disable>]
help
netstat
ntp
[-OM [enable | disable]]
[-p <primary NTP server>]
[-s <secondary NTP server>]
ping
[<IP address or DNS name>]
portspeed
[-s [auto | 10H | 10F | 100H | 100F]]
prompt
[-s [long | short]]
quit
radius
[-a <access> [local | radiusLocal | radius]]
[-p# <server IP>]
[-s# <server secret>]
[-t# <server timeout>]
reboot
resetToDef
[-p [all | keepip]]
snmp, snmp3
[-S [enable | disable]]
system
[-n <system name>]
[-c <system contact>]
[-l <system location>]
tcpip
[-i <IP address>]
[-s <subnet mask>]
[-g <gateway>]
[-d <domain name>]
[-h <host name>]
tcpip6
[-S [enable | disable]]
[-man [enable | disable]]
[-auto [enable | disable]]
[-i <IPv6 address>]
[-g <IPv6 gateway>]
[-d6 [router | stateful | stateless | never]]
uio
[-rc <dI> [open | close]
[-st <port # | port #]]
[-disc <port # | port #]]