APDM Opal V2R - EMC Immunity for Non-life-supporting Equipment

To Next Page

To Previous Page

Table A-3: Guidance and Manufacturer’s Declarations – Electromagnetic Immunity for Non-life-supporting Equipment

The Opal System is intended for use in the electromagnetic environment specied below. The customer or user of the

Opal System should assure that it is used in such an environment.

Immunity Test IEC 60601 Test Level Compliance Electromagnetic Environment - Guidance

Portable and mobile RF communications equipment should be used no closer

to any part of the Opal System, including cables, than the

recommended separation distance calculated from the equation applicable to

the frequency of the transmitter.

Recommended separation distance:

Conducted >= 6 VRMS 3 VRMS d = 1.2√P

Immunity 150 kHz to

IEC 61000-4-6 80 MHz

Radiated Immunity >= 10 V/m 10 V/m d = 1.2√P 80 MHz to 800 MHz

IEC 61000-4-3:2010 80 MHz to d = 1.2√P 880 MHz to 2.5 GHz

2700 MHz

Where P is the maximum output power rating of the transmitter in Watts

according to the transmitter manufacturer and d is the recommended

separation distance in meters.

Field strengths from xed RF transmitters, as determined by an

electromagnetic site survey

, should be less than the compliance level in each

frequency range

Interference may occur in the vicinity of equipment marked with the following

symbol:

Parts

Setup M.L. How to