13
Step 6: Connecting The System
Summary of Tubing Connections:
There are 4 connections: See Fig. 11 and 11A
Point A to X: Connect RO to COLD water supply — Red tubing.
Point G to Y: Connect product water from 5
th
-stage filter to tank — Yellow tubing. This tubing
is a 2-way line, Product water enters and leaves the tank via this line.
Point H to Z: Connect product water from 5
th
-stage output to RO faucet — Clear tubing.
Drain line to W: Connect waste water from 4
th
-stage membrane to drain outlet — Black tubing.
Please Note: The diagram below is for our Non Pump RO-90 and RO-PH90. If you are install
ing the RO-Pump, please refer to the diagram in the addendum.
Fig. 11
1
ep
: Connecting The Syste
mmary o
Tubing Connecti
h
r
r
4
nn
ti
n
See Fig. 11 and 11A
int
Connect RO to COLD water supply
tubing.
int
t
Connect product water
rom 5
th
s
r to tank
s a 2-way line, Product water e
s
leaves the tank via this line.
Connect product water
r
tage output to RO
aucet
n lin
t
Connect waste water
stage membrane to drain outlet
Please Not
The diagr
is
or our Non Pump RO-90 and R
. I
you are install
ing t
mp, please re
er to the diagram in the addendum.
1