Apeman C570 - Solutions to Common Problems; Installation and Image Issues

Solutions of common problems
In the process of installing the cam
1. Suction cup falls off/ unstable
Solution:
A: Please tear off the protective film of the suction cup before installation.
B: Please clean the windshield before installation.
C: Check whether the suction cup has been installed in right way. The
suction cup installation of this cam is not simply adsorption. It needs to
install through the black handle on the suction cup.
2. View files on the cam and find that images are blurred
Solution: The front windshield has reflective effect. Please adjust the angel
of the machine according to the installation position of the suction cup.
3. Big difference of videos recorded in daytime and at night
Solution: The transmittance of commonly used can front glass thermal
insulation films is 68%-80%, which will affect the recording effect of
machine.
4. The cam often shut down or can not connected to the power supply
Solution:
A: The interior design varies from car to car. Please adjust the rotation
angel of the vehicle power adaptor properly, and ensure the stable link
between the power supply and machine.
B: The built-in battery of the machine can only last for 10-15 minutes.
When you use it, please connect it to the power supply.
C: Check if there is any damage to the power lead so as to ensure the
power supply of the machine.
D: If the cam can’ t be used in the car, try to connect the cam to other
power source to see whether the power supply of the car cigar lighter is
normal.
13