- -
Maintenance
Schedule & Tips
It is important that you adhere to this maintenance schedule so as to promote the longevity of your ATV.
Between each ride:
o Inspect the fuel filter for contaminates.
o Check the air filter (clean and re-oil as necessary).
o Ensure the smooth operation of the throttle cable (throttle soundly ‘clacks’ shut).
o Check for frayed strands of the throttle cable inside the throttle housing and replace if necessary.
o Check for adequate tire pressure and adjust if necessary.
o Check all nuts and bolts for proper torque and re-torque if necessary.
o Spray all moving parts with WD40 or other light oil.
o Check drive chain for:
Proper tension and adjust if necessary.
Adequate lubrication and lubricate if necessary.
o Check frame for cracks in the metal or cracks in the paint that might indicate that the metal has
been stressed beyond its safe limits. Replace or re-weld frame as necessary.
Every 10 hours:
o Have the shocks checked and serviced by an Apex certified shock service center.
o Have the clutch checked and serviced.
Warning:
When welding the ATV, disconnect the spark plug cap, unplug the ignition, disconnect the kill switch,
scrape the paint bare near the area to be welded and put the ground clamp as close the area to be
welded as possible.
Be sure the fuel tank and carburetor have been removed and safely located away from the welding
process.
Use proper rod and heat settings for material.
Clutch Tuning Procedure
Disassembly
To Next Page
Loading...