APG Boomtouch - User Manual

BATTERY WARNINGS:
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries.
• Batteries must be inserted with the correct polarity.
• The supply terminals are not to be short-circuited.
• Remove batteries if the item will not be used for an extended period of time.
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the item before being charged.
• Rechargeable batteries are only to be charged under adult supervision.
• Only batteries of the same or equivalent type as recommended are to be used.
• Exhausted batteries should be removed from the item.
Your BoomTouch™ Speaker
Battery Installation
Powering Up Your BoomTouch™ Speaker
Speaker
Sensor Points
Battery Compartment
For helpful hints and useful tips, please visit: www.BoomTouchTips.com
INSTRUCTION MANUAL
1
Turn the speaker on with the ON/OFF Switch on back. The
LED light will illuminate blue when on.
ON/OFF
Switch
LED Light
Turn The Power ON
2
Place your phone on top of the BoomTouch™ Speaker with
the phone’s speaker aligned with the 2 speaker symbols on
the back of the unit.
Back
Align Your Phone
1
Remove battery compartment cover located on the bottom
of the BoomTouch™ Speaker.
2
Insert three “AA” batteries (not included) in the polarity
direction shown on the battery compartment. Replace the
battery compartment cover.

Summary

BoomTouch Speaker Overview

Battery Installation and Warnings

Install Batteries

Remove battery compartment cover and insert three "AA" batteries with correct polarity.

Powering Up Your BoomTouch Speaker

Turn The Power ON

Activate speaker using the ON/OFF switch; the LED light will illuminate blue when on.

Align Your Phone

Place phone on speaker, aligning its speaker with the unit's symbols for optimal sound.

Sound Quality Tips

Set Device Volume

Set phone volume to ~50% initially, then adjust for desired sound.

Play Music Consistently

Use music with consistent volume to find the best phone placement on the speaker.

Adjust Phone Alignment

Experiment with phone position or remove case if sound is not amplified.

Alternative Power and Audio Input

DC 5 V IN Port Use

Power the speaker via a standard micro USB cable; this port does not charge batteries.

Auxiliary Audio Input

Connect audio devices using a mini-jack cable into the Audio IN jack.

APG Boomtouch Specifications

General

Signal-to-Noise Ratio	≥80dB
Bluetooth Version	4.2
Connectivity	Bluetooth
Input Sensitivity	500mV
Bluetooth Range	10 meters