Aplus PlusIII-6KLRB - Page 14

Note：
●: Lightened constantly
△ : #1-#4 Lightened circularly
★: Flashing
↑: Depended on the fault/warning status or other status
Table 5-3 Alarm definition
UPS condition
Buzzer status
Fault active
Continuous
Warning active
Beep every second
Ba tery output
Beep every 4 seconds, if battery low,
buzzer Beep every second
Bypass output
Beep every 2 minutes
Overload
Beep twice every second
The UPS provides useful information about UPS itself, load status, events,
measurements, identification, and settings through the front panel display. During
powering on, the LCD would display the Welcome logo for several seconds and then
enter to the default page which shows the UPS status summary.
The display automatically returns to the default UPS status summary screen when no
button has been pressed for 15 minutes.
On the UPS status summary screen it provides the following information:
⚫ Status summary, including mode and load
⚫ Alarm status, if any are present
Notes: alarm including fault and warning information
⚫ Battery and charger status, including battery voltage, charge level and charger
status
⚫ Running information including parallel UPS and running time