Need help?Do you have a question about the APM SP-300 Series and is the answer not in the manual?
Important safety information and warnings for equipment use, including symbols for danger and caution.
Defines the content, intended users, and required knowledge for manual comprehension.
Covers reproduction rights, update policy, and legal restrictions for manual content.
Itemized list of components and steps to inspect for transit damage.
Guidance on reporting and handling product failures or repairs.
Details the core technologies and highlights key functionalities of the AC power supply.
Guidance on operating procedures, environmental conditions, and cleaning.
Guidelines for storage, voltage verification, fuses, warm-up, and startup.
Detailed layout and functions of the front panel controls and display.
Identification and purpose of connectors and ports on the rear panel.
Instructions for EXT. V and TTL control signals.
Overview of the menu hierarchy and navigation principles.
How to operate the unit using front panel controls and touch screen.
Configuration options for output parameters, measurements, waveform viewing, and limits.
Adjusting display, calibration, remote control, and other system settings.
Performing various output tests including PLD, Harmonics, IEC standards, Special Functions, and Test Mode.
Procedures for Voltage Dips and Variations tests according to IEC 61000-4-11.
Procedures for Flat Curve and Over Swing tests according to IEC 61000-4-13.
Procedures for Voltage Fluctuation Immunity tests according to IEC 61000-4-14.
Procedures for Power Frequency Immunity tests according to IEC 61000-4-28.
Simulating voltage spikes and sags for transient testing.
Regulating active power by adjusting lighting intensity.
Comparing measured parameters against set limits for PASS/FAIL results.
Saving and retrieving output or system configuration settings.
Configuring individual units to operate as slaves in a multi-unit setup.
Configuring a unit to act as the master controller in a multi-unit setup.
Steps for wiring and setting up units in parallel, series, or 3-phase modes.
Troubleshooting error codes and detailing function availability across modes.
List of required equipment and initial steps to access calibration.
Detailed procedure for calibrating voltage settings and measurements.
Detailed steps for calibrating current measurement functions.
Process for saving new calibration values to the device.
Physical size specifications and rack mounting diagrams.
Instructions for attaching rack hardware and installing interface cards.
Critical safety warnings and procedures for connecting AC power input and output.
Configuring local and remote sensing for voltage regulation.
Duration of coverage and conditions for warranty service.
Limitations of liability and conditions under which warranty may be refused.
General| Brand | APM |
|---|---|
| Model | SP-300 Series |
| Category | Power Supply |
| Language | English |
To Next Page