Point scanning lets you select an item on the screen by pinpointing it with scanning
crosshairs.
Switch to point scanning. Use item scanning to choose Point Mode from the control
menu. The vertical crosshair appears when you close the menu.
Select an item. Trigger your Select Item switch when the item you want is within the broad,
horizontal scanning band, then trigger again when the fine scanning line is on the item.
Repeat for vertical scanning.
Refine your selection point. Choose Refine Selection from the control menu.
Return to item scanning. Choose Item Mode from the control menu.
Settings and adjustments
Adjust basic settings. Go to Settings > General > Accessibility > Switch Control, where
you can:
Add switches and specify their function
Choose, create, and edit recipes
Choose a scanning style
Adjust how rapidly items are scanned
Turn off auto scanning (only if you’ve added a Move to Next Item switch)
Set scanning to pause on the first item in a group
Choose how many times to cycle through the screen before hiding Switch Control
Choose a tap behavior and set the interval for performing a second switch action to show
the control menu
Set whether a movement action is repeated when you hold down a switch, and how long
to wait before repeating
Add another action to a switch by holding down the switch for a long duration
Choose which items appear in menus and the order in which they appear
Set whether and how long you need to hold a switch down before it’s accepted as a
switch action
Have Switch Control ignore accidental repeated switch triggers
To Next Page
Loading...
