Apple PowerBook - Page 72

Inverter BoardTake Apart
PowerBook (FireWire)
23
2. Disconnect the display
cable.
3. Remove the T-8 screw
on the display cable to
the left of the inverter
board.
4. Peel the ferrite bead
attached to the display
cable off the top case to
allow you to move the
cable out of the way.
5. Tilt the inverter board
slightly toward you to
disengage the hook on
the left end of the board
from its holding slot,
then lift the board up
until the hook is clear
of the slot.
6. Slide the inverter
board straight to the
left until the hook on
the right end of the
board clears its
holding slot. Do not
bend the board.
7. Disconnect the
inverter cable at the I/
O logic board and pull
it out of its routing.