2.
The Apple lll's
cover
is attached to the
case by
two
screws
(Figure
2-1) located
on the underside of the left and right corners
of the
face
of
the
computer.
Remove the
cover as follows:
a.
Remove
all
cable
connections
lrom the back
of the
Apple lll
so that
you
do not
accidentally damage a connector
when
you
tilt the comDuter
b.
Tilt the Apple lll
slightly to either side,
then
use a short
flat-
bladed screwdriver
(not
supplied) to turn the corresponding
screw one-quarter turn in
eilher direction.
The
screws should
fall
loose, however they won't fall
out of the case because
they are held captive.
c.
Carefully remove
the cover by tilt,ng it straight forward and
liftino it
uo.
Because ol electromagnetic
interference regulalions,
lhe
United Slates Federal Communications Commission
(FCC)
prohibits
the operation ol an
Apple lll
wilh its
cover
removed.
To remind
you
of this, there is a small
red light
on lhe
leil
side of the main board,
near
the
back. ll
you
see that this
light
is on, TUBN YOUR
APPLE lll OFF.
(Don't
forget lo save any
programs
or
dala
you
might be working on.) Fìemember, never
remove
the cover from Ìhe Apple lll,
or connect or
disconnect any{hing on
eilher
the Apple lll
or
lhe
ProFile while the
power
is
on.
Look down
into
the
rectangular
well on the inside of the Apple lll
and locate the four identical
peripheral
card connectors
(usually
called slots) on
tho
main
circuit board. Seo
Figure
2-2.
The
software
supplied
with
your
drive requires
you
to install
the
ProFile
interface
card
in
slot
4,
the closest slot to
your
right when looking
into the
comouter
from the kevboard
side.
You
can
choose
any slot, but
il
you
choose a slot other
than
slol
4,
you
must reconfigure
your
software by
changing lhe
peripheral
slot assignment of the ProFile
driver as exolained
in
Chaoter 3.
3.
Preparing To
Use
Your
Drive
To Next Page
Loading...