.****a1*jl1Eq1Ef!|rF!'!l
Notice that the
READY
(red)
light on the
front
panel
comes
on for an
instant
and
then
goes
out
for
about 20 seconds
while the drive comes
up
to operating
speed. Then the
light flashes for about 60 seconds
while
the
drive
performs
some
internal tests on its disks. After that,
the light
comes
orì and stays on continuously
(does
not flash) to indicate that
the
startup
operalion
is
complete and
your
drive
is ready for operation.
Failure of the
READY light to
stay on after
the slartup operatron
indicates a
possible
drive
malfunction. lf this
condition occurs,
turn
OFF
your ProFile
and contact
your
dealer
for
service.
lf the READY light stays on,
you
are ready
to
connect
your
drive to
the
computer
First, turn OFF
your
ProFile
and unplug
its
power
cord.
Next,
remove the foam end caps and
place your
drive close to the computer.
lnstalling
the
ProFile Interface Card
WARNING:
Electrical equipmenl can
be hazardous il
misused. Operation
of this or similar
producls
must
alwavs
bo sup€rvised by an
adult Th€ installation of
producls,
including
peripheral
and
interlace
devtces
must be oerformed bv an adult
Do not allow children
access
to lhe inlerior of any eleclrical
producl
or lo
handle
power
or
tO
cables.
The interface card
is
a
device that exchanges
address, data, and
control
information between
the Apple
lll
and
the ProFile controller
Before
you
can
inslall the card,
you
must remove the Apple llls
top
cover
to allow
access to the
inside
of the
computer.
1.
Turn
OFF
the
power
switch
on the rear of
the
computer and
any
other attached oerioheral
devices.
lf
you
lry
to connecl or disconnect anything
inside
of
the compuler
when
power
is
on,
you
are
likely
to
damage the circuitry.
ProFrle Owner's
Manual
To Next Page
Loading...