Working Standard
User’s Guide
WS-UGFW619-EN www.appliedp.com
OPERATOR who is permitted to gain access, using a Product, to a part which in NORMAL USE may
be HAZARDOUS LIVE, must ensure that the equipment must be isolated or disconnected from the
HAZARDOUS LIVE voltage before access. That means that electricity meter is being connected to
Product when it is turned off.
Lithium primary battery notice
DANGER of explosion if battery is incorrectly replaced.
When replacing the lithium coin-cell battery, use only the same type or equivalent type that is
recommended by the manufacturer. The battery contains lithium and can explode if not properly used,
handled, or disposed of. Do not:
• Throw or immerse into water
• Heat to more than 100°C (212°F)
• Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
Disposal and recycling information
Batteries and electrical and electronic equipment marked with the symbol of a crossed-out
wheeled bin may not be disposed as unsorted municipal waste. Batteries and waste of
electrical and electronic equipment (WEEE) shall be treated separately using the collection
framework available to customers for the return, recycling, and treatment of batteries and
WEEE. When possible, remove and isolate batteries from WEEE prior to placing WEEE in
the waste collection stream. Batteries are to be collected separately using the framework
available for the return, recycling, and treatment of batteries and accumulators.
Hazardous voltage. Risk of electric shock.
Risk of Danger. Important information. See Manual.
Conforms to European Union directives
LIMITED WARRANTY AND LIMITATION OF LIABILITY
This Applied Precision product will be free from defects in material and workmanship for warranty period
from the date of purchase. This warranty does not cover fuses, disposable batteries, or damage from
accident, neglect, misuse, alteration, contamination, or abnormal conditions of operation or handling.
To obtain service during warranty period, contact your reseller or directly the authorized Service Centre
to obtain return authorization information, then send the product to that Service Centre with a
description of the problem.
This warranty is your only remedy. No other warranties, such as fitness for a particular purpose, are
expressed or implied. Applied Precision is not liable for any special, indirect, incidental or
consequential damages or losses, arising from any cause or theory.
Since some states or countries do not allow the exclusion or limitation of an implied warranty or of
incidental or consequential damages, this limitation of liability may not apply to you.
Manufacturer address:
Applied Precision Ltd.
Stavitelska 1
831 04 Bratislava
Slovakia
Technical support contact:
support@appliedp.com
Service Centre:
Applied Precision Ltd.
Stavitelska 1
831 04 Bratislava
Slovakia
To Next Page
Loading...
Need help?
General
